This in vitro study had a randomised and blinded design. Tokens of poly(methylmethacrylate) resin were fabricated according to the manufacturer’s instructions. After this, the surface roughness was measured and the tokens were randomly divided into 12 groups for the biofilm assays. Biofilms of one reference strain and two clinical isolates of C. albicans (ATCC 90028, P01 and P34) and C. glabrata (ATCC 2001, P11 and P31) were allowed to develop on token surfaces. Control and experimental groups were formed. FLZ at 2.56 μg/mL, the concentration bioavailable

in saliva, 15 was added to the medium of the experimental group. The biofilms were developed for 48 h, and the bioactivity was evaluated using an XTT (sodium 3′-[1-(phenylaminocarbonyl)-3,4-tetrazolium]-bis (4-methoxy-6-nitro) benzene sulfonic acid hydrate) reduction colorimetric FK866 assay. Confocal scanning laser microscopy (CLSM) and transmission PI3K cancer electron microscopy (TEM) were used for cellular structure analyses. Tokens were fabricated using acrylic resin polymerised by a hot water bath

(QC-20 PMMA – Dentsply Ltd., Weybridge, England), according to the manufacturer’s instructions, at room temperature (25 ± 1 °C) and 50 ± 5% (relative humidity) under aseptic conditions, using a metal matrix (10 mm diameter and 2 mm thick). The tokens were immersed in distilled water at 37 °C for 12 h for residual monomer release.16 Then, the tokens were ground using progressively smoother aluminium oxide papers (320, 400 and 600 – grit) in a horizontal polisher (model APL-4; Arotec, Sao Paulo, Brazil). Next, the tokens were disinfected with 70% alcohol, washed twice with sterile distilled water and then ultrasonicated for 20 min to remove any contaminates and residues from the surface. Surface roughness of the acrylic resin tokens was measured using a profilometer (Surfcorder SE 1700; Kosaka Laboratory Ltd., Kosaka, Japan) accurate to 0.01 μm with a total measurement length of 3.2 mm and 0.5 mm/s. Three readings were made for each token, and a mean value was calculated.17 The average surface

roughness obtained Carteolol HCl was 0.31 ± 0.02 μm. Biofilm assays were performed using two reference strains: C. albicans ATCC 90028 and C. glabrata ATCC 2001 and two clinical isolates of each strain (P01 and P34) and (P11 and P31), respectively. The clinical isolates were obtained from the surface of the acrylic prosthesis of patients without symptoms of oral candidosis. Before the experimental procedures, the identity of all isolates was reconfirmed by the CHROMagar®Candida test (Difco Laboratories, Detroit, MI, USA) and the carbohydrate assimilation test using the Vitek-2 identification system (bioMérieux, Marcy l’Etoile, France). 18 Prior to each experiment, each Candida strain was grown aerobically on Sabouraud dextrose agar at 37 °C for 18 h.