Solutions with concentrations of 10-3 and 10-4 M for PAH and PSP were prepared; in all cases, the mixtures had a 0.15 M NaCl to set the ionic strength. The pH

of both solutions was adjusted to 6.37 with NaOH or HCl [23]. The nanofilms were developed by either dipping the substrate into the 10-3/10-4 M solutions or by spraying the different solutions on the substrate. Therefore, up to four different growing conditions were studied (10-3 and 10-4 M of LbL dipping and 10-3 and 10-4 M of spray-assisted LbL). The anchoring layer of PEI led a positive superficial density charge onto EPZ-6438 purchase the fiber so that each bilayer shows the structure PSP/PAH. Films with 20, 40, 60, 80, and 100 bilayers were prepared in each growing configuration

in order to study the effects of the construction parameters. In the case of the dipping process, each construction cycle was performed by immersing the slide into the PSP solution for 2 min and then rising it in ultrapure water for 1 min; thereafter, it was dipped into the PAH mixture for 2 min and rinsed again for 1 min in ultrapure water. This process was repeated as many times as required for the film. The steps were similar for the spray technique: the polymeric solutions and ultrapure water were sprayed for 10 s onto the slides. Both methods were automated by using a robotic arm (in the case of the dipping construction) and a spraying robot (both of them acquired from Nadetech https://www.selleckchem.com/products/Nolvadex.html Innovations S.L., Sarriguren, Spain). Characterization

The films prepared were characterized in order to study the growing process depending on the construction conditions. One of the key parameters, roughness, was measured by an atomic force microscope (AFM) very (Veeco Innova, model 840-012-711; Veeco Instruments, Inc., Plainview, NJ, USA) in tapping mode; it was also used to register the thickness of the films by scratching the surface with a needle and scanning the cantilever perpendicularly to the scratch. For each sample, the AFM measurements were performed seven times in different zones to get the mean value and the standard deviation. AFM images were obtained by scanning 5 μm × 5 μm areas with 512 lines at a 0.1-Hz frequency. UV/Visible transmission spectra were recorded by a spectrometry transmission configuration, placing the glass slide under study in a holder between a white light source (HL2000; OceanOptics, Dunedin, FL, USA) and a spectrometer (USB2000XR1, OceanOptics). Finally, the contact angle was registered using a contact angle meter (KSV Instruments goniometer; Espoo, Finland) for each sample. Results and discussion As it was cited before, four sets of samples were prepared: 10-3 and 10-4 M of LbL dipping as well as 10-3 and 10-4 M of spray-assisted LbL. In each set, five slides were coated with different number of bilayers (20, 40, 60, 80, and 100).